3.3.8 kill and kill_diags
The
kill
and
kill_diags
commands terminate diagnostics that are currently
executing .
Note
A serial loopback connector (12-27351-01) must be installed on the COM2
serial port for the
kill_diags
command to successfully terminate system
tests.
• The
kill
command terminates a specified process.
• The
kill_diags
command terminates all diagnostics.
Synopsis:
kill_diags
kill [PID . . . ]
Argument:
[PID . . . ] The process ID of the diagnostic to terminate. Use the
show_status
command to determine the process ID.
3–16 Running System Diagnostics
Comentarios a estos manuales